Owner`s manual

F321 2080 1100 4301 003D EDB0 C300 43

Look at the line and compare it to the line above. If it's correct, you can press

[ENTER] to leave the Modify mode. If you find you've made a mistake, you can simply

use the arrow keys to move the white block over to where it is covering the incorrect

entry. Make any corrections needed. Press [ENTER] to exit the Modify mode.

You are now finished with DEBUG. (You've just written a machine language

relocation program—Congratulations!!) Press [Q] for Quit to go to TRSDOS Ready.

At TRSDOS Ready, enter the following line exactly without any spaces (except for the

two spaces shown:

DUMP BEDLAM/CMD (START=8020,END=0BD3F,TRA=0BD30)

and press [ENTER]. The Bedlam program is now properly moved to diskette under

the file name, BEDLAM/CMD. To run Bedlam, just type [B][E][D][L][A][M] and press

[ENTER] at TRSDOS Ready.