Owner`s manual

If you want the pager to have a new pager code,

enter the new 3-digit pager code and

, then press

PAGE

After you press

PAGE

, the transmitter flashes the 4-

digit code seven times and transmits the pager and

system codes to the pager. After the codes are trans-

mitted, the digits remain on the display until you:

• Turn off the transmitter.

• Press

CANCEL

. - - - - appears.

• Send a message to the pager. The 4-digit code

flashes.

5. Once the pager code is stored, turn the pager off,

then on again before attempting to transmit a mes-

sage code.

Repeat Steps 1–5 to store or replace a code for each

pager used.

Notes:

• If the pager does not successfully store the pager

code, repeat the steps.

• You must reset all the pager’s codes when you store

a new system code in your transmitter.

17-6024.fm Page 7 Friday, August 6, 1999 11:00 AM