Installation manual

Function 5: Voice mail programming IVX 128
H.6
Cascade paging parameters
The cascade paging mailboxes will use the same CO line group and pager dialing pause as pro-
grammed in Function 552 (see page H.5).
Paging interval
To program the paging interval parameter for a cascade paging mailbox:
1.
Enter the mailbox number
(520–529)
.
2.
Press
2
to set parameters for the mailbox.
3.
Enter the number of minutes for the interval between attempts.
Range:
10–1440.
Default:
0.
Note:
Once you change this setting from
0
, you cannot reset it to
0
.
Function 57: Q & A mailboxes
You can create up to 10
question and answer (Q & A) mailboxes
(490–499). Each Q & A mailbox
owner can record up to 10 questions. The questions are recorded in the same manner as recording
users’ multiple personal greetings (see
User’s Guide
). The individual answer segments recorded by
the caller are stored as a single message, with the answer segments separated by short beep tones.
Each answer segment's maximum length will be as programmed in Function 51 (see page H.1). Nor-
mal message handling capability — delete, save, etc. — applies to the entire message (all segments).
The caller, when recording each answer, can be instructed to conclude by pressing
1
or to pause for
the next question (the system advances when it detects either a 3-second period of silence or the
pressing of
1
) —
e.g., "Record your name at the tone and press 1 when finished”… “Record your
address at the tone and press 1 when finished".
If the caller fails to respond to two questions in a row, the system disconnects the call.
Important:
This programming creates or deletes Q & A mailboxes, but these mailboxes are
turned “on”
only
when the mailbox owner has recorded questions. Similarly,
deleting all questions turns “off” the mailbox.
To record questions, press
PROG/HELP
* and the mailbox number; then press
#
to confirm, and fol-
low the prompts. The default password is the mailbox number.
Below is an example of a completed Programming Worksheet (numbers correspond to steps on
next page):
1. 2. 3. 4.
MB Name CF day CF night
490
Employment X/MB/ID X/MB/ID
491
Survey X/MB/ID X/MB/ID