Installation manual

IVX 128 Function 5: Voice mail programming
H.5
Function 552: Delivery/paging parameters
The sequence of programming is as follows:
1.
CO line access
— Enter the CO line group (9, 8, or 71–76) that is to be accessed for delivery.
Default:
9.
2.
Maximum lines
— Enter the maximum number of lines (in the selected CO line group) that the
system can access simultaneously. Make enough lines available to accommodate high notifica-
tion traffic (but be careful: if you make available
all
lines in the selected line group
and
high
notification traffic occurs, the system could tie up all lines).
Range:
1–19.
Default:
1.
3.
Pager dialing pause
— When paging, IVX 128 will send the mailbox number to be shown in the
pager’s display. To allow time for the paging service to answer, enter the pause, in seconds, to
occur between when IVX 128 dials the pager number and when it then dials the mailbox number.
Range:
0–20.
Default:
6.
Function 56: Cascade paging mailboxes
In addition to individual mailbox paging, IVX 128 can support up to 10 cascade paging mailboxes
(520–529). These can be assigned to anyone who requires escalating levels of paging beyond the
single level available in all user mailboxes. In this function, you program the paging numbers and
number of times each is to be paged before the next paging number is added; additionally, the mail-
box owner can program these settings. To record a greeting, press
PROG/HELP
* and the mailbox
number; then press
#
to confirm, and follow the prompts. The default password is the mailbox number.
Cascade mailbox options
The user can program up to three paging numbers, of up to 24 digits each, to be paged whenever the
mailbox takes a new or urgent message. The system will page the first paging number (for the number
of times listed), then add the second paging number (for the number of times listed), then add the
third paging number and will continue to page all three pagers until the message has been retrieved.
1. 2. 3. 4. 5. 6.
MB 1st Number Attempts 2nd Number Attempts 3rd Number
520
9725553232 2 9725554254 3 9725555452
To program this, enter:
1.
The mailbox number
—
Range:
520–529. [Then press
1
to enter number programming, and
proceed to step 2.]
2.
First pager number
— The number to be dialed (
without
the CO line Group
[9, 8
or
71–76]).
3.
Attempts
— How many times the system will page (up to 20) before adding the second
pager number.
Range:
0–99. (0 turns off delivery.)
4.
Second pager number
— The number to be dialed (
without
the CO line Group
[9, 8
or
71–76]).
5.
Attempts
— How many times the system will page (up to 20) before adding the third
pager number.
Range:
0–99. (
0
turns off delivery.)
6.
Third pager number
— The number to be dialed (
without
the CO line Group
[9, 8
or
71–76]).
Note:
Here is how to enter certain characters in a pager number.
For a
#
, press
TRANSFER
.
For a
P
(two-second pause), press
CONF
.
For an F (flash), press
FLASH
.
For a *, press
REDIAL
.