Installation manual

Function 1: System parameters IVX 128
D.2
Function 14: Set time/date
1.
Enter a new time in a
twelve
-hour format.
Example:
Enter
1 2 3 3
for
12:33
, or
3 1 5
for
3:15
(note that you need
no
leading zero for
the time).
2.
Select
AM
or
PM
by pressing a scroll key (either ▼ or ▲
).
3.
Enter a new date in an
eight-digit
format,
including
leading zeroes.
Example:
Enter
0 7 0 4 2 0 0 0
for July 4, 2000 (note that leading zeroes
are
required here,
unlike in step 1).
4.
Press
#
to finish the entry.
Note:
A built-in battery maintains the correct time and date, even in the event of a power loss.
Function 15: System timing parameters
Function 151: Flash hook duration
This sets the time (in seconds) that a flash hook will be sent on the current line to the Telco. The
default setting of
1.5
will cause disconnect and fresh dial tone from the CO.
Range:
0.2–2.0.
Default:
1.5.
Function 152: Transfer recall timer
This sets the number of times a transferred call will ring before following the day/night routing for
the extension or department.
Range:
1–9 rings.
Default:
3.
Function 153: Hold/park recall timer
This is the amount of time, in seconds, that a call will remain on hold or park before recalling to the
extension that initiated the park or hold.
Range:
5–960 seconds.
Default:
60.
Function 154: ACD exit timer
This is the amount of time, in seconds, that a call will remain in ACD department queues before
following the department reroute (see Function 33, page F.7).
Range:
5–600 seconds (or 0 for no limit).
Default:
180.