Installation manual

System programming: an introduction IVX 128
C.4
System programming overview
1 System parameters
11 Initialize
12 Installer password
13 Administrator password
14 Set time/date
15 System timing parameters
151 Flash duration
152 Transfer recall timer
153 Hold/park recall timer
154 ACD exit timer
155 ACD wrap timer
156 Cell phone delay
16 Recording alert tone
17 System speed dial
18 Serial port baud rate
2 CO line programming
21 Line programming
211 Analog CO line programming
212 T1 programming
2121 CO line programming
2122 Frame format and line coding
2123 Line build-out
2124 CSU emulation
22 Access codes/toll restriction
221 Centrex/PBX access code
222 Toll restriction exception tables
223 ARS (Automatic Route Selection)
224 DID translation table
23 Line parameters
231 Line receive volume
232 Line open-loop Interval
233 Line receive volume
24 Caller ID programming
3 Extension programming
31 Extension definition and routing
32 Extension feature authorization
33 Department groups
35 Extension button mapping
4 Auto attendant programming
41 Auto attendant branch programming
42 Announce extension number
43 Automatic day/night mode table
5 Voice mail programming
51 Maximum message length
52 Message purge control
53 Guest/info mailboxes
54 Group mailboxes
55 Message notification options
551 Station delivery options
552 Delivery/paging parameters
56 Cascade paging mailboxes
561 Cascade mailbox options
562 Cascade paging parameters
57 Q & A mailboxes
6 Recording
61 Record system prompts
62 Record directory names
63 MOH programming
631 MOH source
632 Record MOH
633 MOH volume
7 Reports
71 System program
72 Line/auto attendant statistics
73 Extension/department statistics
74 Voice mail statistics
75 System speed dial list
How to program the IVX 128 system
You may program from
any
IVX Series phone in the system:
1.
Press
PROG/HELP
. The normal
station
programming menu prompt will begin to play.
2.
Press
PARK
to stop the prompt.
3.
Enter the Installer password, followed by #.
You are now in programming mode.
Note:
While in programming mode, the extension will be automatically placed in DND.
4.
Follow the
system
programming menu to program as you wish; and, when finished, hang up.
Note:
The system will automatically exit programming mode after 10 minutes of inactivity.
Example:
To
enter
programming mode, press
PROG/HELP, PARK, 7 8 9 [or new Installer
password], #.
To
exit
programming mode,
hang up.