Installation manual

IVX 128 Hardware overview/installation
B.9
Base Cabinet I
Base Cabinet II
Opening the cabinet
The lid on all cabinets is held in place by two tabs that rest in slots in the
bottom of the case, and a release tab that snaps into an opening in the top-
center of the cabinet and is secured by a retaining screw.
To remove the lid:
1.
Remove the retaining screw and depress the release tab at the top of the
cabinet.
2.
Rock the lid back from the top.
3.
Lift and pull the lid free from the slots in the bottom of the cabinet.
Mounting the Base Cabinet(s)
Use three #8 hex-head screws. Note the position of the three mounting holes in IVX. Allow room for
installation of the second base cabinet either now or if required in the future. The Base Cabinet II
must be installed directly below the Base Cabinet I. Allow about 2
″
clearance between the units.
1.
Screw in the top screw to the backboard (at least half-inch thick
plywood) leaving about one-eighth-inch clearance between the screw
head and the plywood.
2.
Hang the unit using the keyhole at the top of the case.
3.
Level the unit and install the bottom two screws.
4.
If necessary, repeat the steps for the Base Cabinet II.
Attach the power transformer to the wall, allowing sufficient length in both
cords to reach the power connector on the upper right side of the cabinet
and to reach a UPS or a dedicated 110 VAC outlet.