Operating instructions

MFJ-933 Loop Tuner
TM
Instruction & Technical Manual
- 20 -
FAST-START INSTRUCTIONS
FAST START OPTION
Although careful and complete reading of the technical manual is certainly
foremost when receiving new equipment, MFJ-933 Loop Tuner
TM
operation can
be achieved with minimum time and effort as long as certain and specific
instructions are followed. Strict adherence to WARNINGS and CAUTIONS
associated with personal safety, coupled with following specific procedural steps
can lead to a unique operating experience in a very short time.
WARNING
DO NOT touch or come into contact with Loop
Connectors or Loop Antenna while transmitting
YOU CAN BE SERIOUSLY INJURED
!!!
NOTICE
It is imperative that the operator specifically follows operating instructions and
complies with all CAUTIONS, WARNINGS, and FCC Guidelines for Human
Exposure to Radiofrequency (RF) Electromagnetic Fields
Step 1
Place the MFJ-933 Loop Tuner
TM
at the chosen place of operation, assemble the
PVC Cross and connect the precut loop antenna found in the MFJ-57B
Accessory Kit to the wing nut terminals on the rear panel. Using the pre-cut loop
antenna, form a loop around the PVC Cross to enclose as much area as
possible. A circle encloses the maximum area.
Step 2
Complete the typical MFJ-933 Loop Tuner
TM
setup configuration as illustrated in
Figure 6 of this manual.