Service manual

PRO-94 Tutorial: Programming Conventional Frequencies
This is an introduction to programming conventional (non-trunking) frequencies into your PRO-94 scanner. This tutorial will involve programming a
frequency into either Bank "A" or "B", selecting which channel number to store a frequency in and storing the frequency. It will also show you how
to set the delay to the "on" or "off" mode. For this tutorial, frequency 866.1625 will be stored in Bank A with delay off.
For additional information on this product, see the links below:
● 200-0524 PRO-94 User's Manual
● 200-0524A PRO-94 User's Manual
● Scanner Basics
● Scanner FAQ's
Step 1: Entering Manual Mode
BankA-1ch-000.000-MAN
Pro94-keypad-MAN
Press MAN. MAN will appear on the display.
Step 2: Selecting the Bank
Hold down A/B (HOLD) for about 2 seconds to select either main group "A" or "B".
Note: When you are first programming the scanner (or after you reinitialize), it defaults to main group A; pressing A/B (HOLD) will changes to
main group B, as above. For our example, we will be working in main group A. If B is displayed, press A/B (HOLD) to go to main group A.
Step 3: Selecting the Channel