Service manual

Product: PRO-94 Scanner Cat. No.: 200-0524

Question: How do I turn off Hypersearch? I can't get HYPER off of the display.

Answer: Hypersearch can only be turned on and off through a limit or direct search. To turn it off, you should do the following:

Through Limit Search:

1. Press PROG, then LIMIT (SRC). Lo and 29.000 MHz appear. 29.000 MHz is the low end of the scanner's range.

2. Enter the frequency that is the lower limit of the range you want to search (including the decimal point), then press E (SVC).

3. Press LIMIT (SRC). Hi and 1300.00 MHz appear. 1300.000 MHz is the upper limit of the scanner's range.

4. Enter the frequency that is the upper limit of the range you want to search (including the decimal point), then press E (SVC) again.

5. Press \/ to search from the upper to the lower limit or /\ to search from the lower to the upper limit.

6. While the scanner is searching or is on a transmission, press H/S.

7. HYPER should disappear from the display.

Through Direct Search:

1. Press MAN.

2. Enter the frequency you want to start from using the number keys. (Press . to enter a decimal point).

NOTE: To start the search from a frequency already stored in one of your scanner's channels, press MAN or PROG. Then use the

number keys to enter the channel number and then press MAN or PROG again. If you enter an invalid frequency, the scanner displays

Error. Press MON/CLR (.).

3. Press \/ to search downward or /\ to search upward from the selected frequency. -d-, SEARCH, and either \/ or /\ appear.

4. While the scanner is searching or is on a transmission, press H/S.

5. HYPER should disappear from the display.

Back to Index Back to Top of Section 4