Service manual

Back to Index Back to Top of Section 3
Product: PRO-2034 60-Channel Programmable Base Scanner Cat. No.: 200-0411
Question: Why am I not getting the last digit on the display between 29-54 MHz and 137-174 MHz?
Answer: In order to enter the last digit, you need to enter frequency manually. However, you will not see the last digit -- you will see a (0) for it
instead. These frequencies have a step rate of 5 kHz.
Back to Index Back to Top of Section 3
Product: PRO-2036 200-Channel Scanner Cat. No.: 200-0412
Question: I need a replacement lithium battery for this scanner.
Answer: The 3-Volt, 180 mAh lithium battery is available as part number RSU 10586923. Because this is available as special order only, you
would need to order it through either your local RadioShack store or by calling 800-843-7422.
Back to Index Back to Top of Section 3
Product: PRO-2038 50-Channel Scanner Cat. No.: 200-0413
Question: Why am I not getting some frequencies in the 450-470 MHz; is it due to rounding?
Answer: Yes, the step frequency (12.5 kHz) is automatic and will always do this.
Back to Index Back to Top of Section 3
Product: PRO-2043 30-Channel Direct Entry Programmable Scanner Cat. No.: 200-0415
Question: Does this have a backlight display?
Answer: No.
Back to Index Back to Top of Section 3
Product: PRO-2043 30-Channel Direct Entry Programmable Scanner Cat. No.: 200-0415
Question: This has lockout showing on all channels, and it won't go out.
Answer: If 000.000 is displayed on the channel, then there is no frequency stored. When you program a new frequency, the lockout is
automatically removed. You cannot remove lockout before programming a channel. If this is not the case, then you may need to reset the
scanner.
Back to Index Back to Top of Section 3
Product: PRO-2050 VHF/UHF/Air/800 MHz 300-Channel Scanner Cat. No.: 200-0430
Question: Why is it giving an error once the frequencies have been programmed in?
Answer: It should not do this. Try resetting, then program the frequencies in different banks and try again.
Back to Index Back to Top of Section 3
Product: PRO-2050 VHF/UHF/Air/800 MHz 300-Channel Scanner Cat. No.: 200-0430
Question: What does this use for memory backup and how long will it hold memory?
Answer: It uses an EEPROM for memory backup and should last years.
Back to Index Back to Top of Section 3