Service manual

Answer: This requires a 9V, 300 mA (minimum) adapter with a 1.3 mm / 3.4 mm plug. The 273-1810 DC/DC adapter meets these requirements
and includes the correct adaptaplug. The
273-1767 AC/DC adapter meets these requirements and comes with your choice of one free plug
(plug "H", Cat. No.
273-1711).
Back to Index Back to Top of Section 3
Product: PRO-51 200-Channel Scanner Cat. No.: 200-0308
Question: Is this a trunking scanner?
Answer: No.
Back to Index Back to Top of Section 3
Product: PRO-76 Scanners Cat. No.: 200-0313, 200-0048
Question: Is there a cable for wired programming for my scanner?
Answer: Yes; this cable and software is available as catalog number
20-048. This is a store-stocked item and can be either purchased through
your local store, ordered through our Catalog Order Center at 800-843-7422, Option 2, (Catalog, Parts and Accessory Ordering) or ordered on-
line by clicking on the catalog number.
Back to Index Back to Top of Section 3
Product: PRO-79 Scanners Cat. No.: 200-0314, 200-0048
Question: Is there a cable for wired programming for my scanner?
Answer: Yes; this cable and software is available as catalog number
20-048. This is a store-stocked item and can be either purchased through
your local store, ordered through our Catalog Order Center at 800-843-7422, Option 2, (Catalog, Parts and Accessory Ordering) or ordered on-
line by clicking on the catalog number.
Back to Index Back to Top of Section 3
Product: PRO-79 Scanners Cat. No.: 200-0314
Question: How do I get the scanner into Wired mode for programming?
Answer: To use the Wired Programming for the PRO-79, you will need to follow the steps below:
Note: Wired programming stops if the scanner receives an empty channel number.
1. Turn off the scanner.
2. Connect the scanner to the PC using a PC cable.
3. While pressing ENT and 9, turn on the scanner. PGM and WirEd appear. Then send the data from the PC. StArt and the data being
received by the scanner appears in the order it is received.
Note: If the scanner receives no data from the PC for more than 20 seconds or if you press any key, wired programming stops. If the
scanner did not receive a start bit from the PC, StArt does not appear.
4. When the scanner successfully receives all data, End and FiniSh appear. If the scanner received an error while receiving data, End and
d-Err appear. If the scanner received a checksum error while receiving data, C-Err and a number appear. The number shown next to C-
Err indicates the packet number where the error occurred.
Note: If the scanner did not receive an end bit from the PC, End does not appear.
Back to Index Back to Top of Section 3
Product: PRO-2029 60-Channel Scanner Cat. No.: 200-0404
Question: How do I program frequencies into this scanner?
Answer: This is programmed as below:
1. Press Manual.
2. Press Program.
3. Enter the frequency.
4. Press Enter.