User manual

Quick Start Guide

Step 4 SELECT FILTER MODE

FILTER mode is selected when the FILTER switch is ON and the CAPTURE switch if OFF.

Frequencies are locked on the display but not logged to memory. The gate setting can be changed by

pressing the GATE/RECALL/CLEAR push-button switch on the front panel.

Step 5 SELECT CAPTURE MODE

CAPTURE mode is selected when the FILTER and CAPTURE switches are both ON. In this mode,

frequencies captured are displayed and stored into memory, along with the number of hits of each fre-

quency. In CAPTURE mode,

the 1KHz resolution gate time is always selected.

Step 6 REACTION TUNING

REACTION TUNING is selected when the Scout is in either FILTER mode or CAPTURE mode. When

interfaced to a compatible receiver the Scout will automatically tune the compatible device to the fre-

quency it captures. Please refer to page 16 & 17 of this manual for detailed instructions on how to set

up each compatible device for REACTION TUNING.

Step 7 SELECT RECALL MODE

RECALL mode is selected when the FILTER switch is OFF and the CAPTURE switch is ON. In this

mode the operator can view all 400 frequencies and all 255 hits in memory. Memories are displayed

as four banks of 100 memories. The “A” and “B” annunciators are used to indicate which bank is

currently being displayed.

Solid “A” indicates memories 0-99

Solid “B” indicates memories 100-199

Flashing “A” indicates memories 200-299

Flashing “B” indicates memories 300-399