Owner`s manual

an upper limit in this step, the scanner displays and uses
894.050 as the upper limit after you press ENTER.
7. Press the UP ARROW to search from the lower to the upper limit, or the
DOWN ARROW to search from the upper to the lower limit. As the scanner
searches, it displays SEARCH, and the bar under the selected search
bank number flashes.
When the scanner finds an active frequen cy, it stops searching. To
save the frequency into a monitor memory, press MONITOR. MON and the
current monitor channel number appear on the display. Press the UP or
DOWN ARROW again to continue searching for additional active
frequencies.
NOTES: If you set the limit search range to a range that is narrower than
the step frequency, the scanner beeps and displays -PASS- when you
press the UP or DOWN ARROW. To correct this problem, either press
STEP to change the step frequency or enter a wider frequency or
enter a wider frequency range in Steps 4 and 6.
As the scanner searches, you can also use TUNING to search through
frequencies manually by pressing TUNE, then turning the TUNING
knob. Press TUNE again to continue the limit search.
During the limit search, you can manually change the frequency step
or band mode. See "Changing/Resetting the Frequency Step" or
"Changing/Resetting the Band Mode."
DIRECT SEARCH
You can search up or down from the currently displayed frequency and store
frequencies you hear during the search into monitor memories.
NOTE: You can use the scanner's delay feature while using direct search.
See "Delay."
1. Press MANUAL or PROGRAM.
2. Use the number keys to enter the frequency you want to start the search
from. Or, use the number keys to enter the channel number containing
the starting frequency and press MANUAL or PROGRAM again.
3. Press DIRECT. SEARCH, -d-, and the starting frequency appear on
the display.
4. Press the UP or DOWN ARROW to search up or down from the selected
frequency.
When the scanner finds an active frequency, it stops searching.
To save the frequency into a monitor memor y, press MONITOR. MON
and the current monitor channel number appear on the display.
Press the UP or DOWN ARROW again to continue searching for more
active frequencies.
NOTES: As the scanner searches, you can also use the TUNING knob to searc h
through frequencies manually by pressing TUNE, then turning the
TUNING knob. Press TUNE again to continue the direct search.
During direct search, you can manually change the frequency step or
band mode. See "Changing/R esetting the Frequency Step" or
"Changing/Resetting the Band Mode."