Owner`s manual

press the UP or DOWN ARROW.
9. To stop auto store, press MANUAL. MANUAL appears.
Limit Search
You can search for transmissions within a range of frequencies you select,
called the limit search range. You can set and store up to ten limit
search ranges into search banks (1 -10).
NOTES: You can use the scanner's delay feature while using limit search.
See "Delay."
When the scanner searches for frequencies within limit search
range, you can store frequen cies you hear during the search into
monitor memories.
Follow these steps to set and store limit search ranges and search them for
active frequencies.
1. Press PROGRAM. PROGRAM appears.
2. Using the number keys, select the number for the sear ch bank where
you want to store a limit search range.
NOTE: To select bank 10, press 0.
3. Press LIMIT. SEARCH BANK and Lo appear, and a bar flashes under the
selected search bank's number. If you already entered limit search
ranges in other search banks, a bar appears under each search bank's
number.
4. Use the number keys to enter the lower limit of the frequency range you
want to search, then press ENTER.
NOTES: If you enter an invalid frequency in Step 4 or 6, the sc anner
displays ERROR. Simply repeat the step.
If you enter any frequency in a range from 823.950 to 823.995
MHz for a lower limit in this step, the scanner displays and
uses 823.950 as the lower limit after yo u press ENTER. If you
enter any frequency in a range from 868.950 to 868.995 MHz for a
lower limit in this step, the scanner displays and uses 868.950
as the lower limit after you press ENTER.
5. Press LIMIT. SEARCH BANK and Hi appear.
6. Use the number keys to enter the upper limit of the frequency range you
want to search, then press ENTER.
NOTES: If you create more than one search bank and you want to review
your limit search ranges, turn TUNIN G one click for each
selected search bank. As you turn TUNING, a bar flashes under
the active search bank number, and either Lo or Hi is
displayed. Press LIMIT to review the high and low limits of
the frequency ranges for the selected search bank.
If you enter any frequency in a range from 849.005 to 849.050
MHz for an upper limit in this step, the scanner displays and
uses 849.050 as the upper limit after you press ENTER . If you
enter any frequency in a range from 894.005 to 894.050 MHz for