Owner`s manual

NOTES: To select a bank that does not contain any empty channels, a
bar flashes under the bank number, and -FULL- and AUTO appear.
To enter new frequencies into this bank, you must delete one or
more frequencies stored in it, then repeat Step 2. See
"Deleting Frequencies."
If you select a bank that contains an empty channel, a bar
flashes under the bank number, and AC -, the number of vacant
channels in the bank, Ch, and AUTO appear.
If you do not want to select the bank, press the bank's number
again.
If you select more than one bank and want to review your
selections, turn TUNING one click for each selected bank. As
you turn TUNING, a bar flashes under each selected bank number.
3. Press LIMIT. Lo appears.
4. Use the number keys to enter the lower limit of the frequency range you
want to search, then press ENTE R.
NOTES: If you enter an invalid frequency in Step 4 or 6, the scanner
displays ERROR. Simply repeat the step.
If you enter any frequency in a range from 823.950 to 823.995
MHz for a lower limit in this step, th e scanner displays and
uses 823.950 as the lower limit after you press ENTER. If you
enter any frequency in a range from 868.950 to 868.995 MHz for
a lower limit in this step, the scanner displays and uses
868.950 as the lower limit after your press ENTER.
5. Press LIMIT. Hi appears.
6. Use the number keys to enter the upper limit of the frequency range you
want to search, then press ENTER.
NOTE: If you enter any frequency in a range from 849.0 05 to 849.050
MHz for an upper limit in this step, the scanner displays and
uses 849.050 as the upper limit after you press ENTER. If you
enter any frequency in a range from 894.005 to 894.050 MHz for
an upper limit in this step, the scanner displays and uses
894.050 as the upper limit after you press ENTER.
7. Press the UP ARROW to search from the lower to the upper limit, or
DOWN ARROW to search from the upper to the lower limit. AUTO and
the bar under the selected bank number flash on the display.
When the scanner finds an active frequency, it stores the
frequency in the displayed channel, then continues searching for
more active frequencies and storing them in any subsequent empty
channels. When the scanner fills all channels within the selected
banks, the scanner beeps rapidly and displays the number of the
last channel where a frequency was stored.
NOTE: During auto store, you can manually change the frequ ency step or
band mode. See "Changing/Resetting the Frequency Step" or
"Changing/Resetting the Band Mode."
8. To interrupt auto store, press AUTO. The scanner displays the last
channel number where a frequency was stored. To continue auto store,