Owner`s manual

Both MON and the frequency stored in the monitor memory are displayed.
MOVING FREQUENCIES
Moving a Frequency from a Monitor Memory to a Channel
1. Press PROGRAM.
2. Use the number keys to enter the channel number where you want to
store the monitor frequency, then press PROGRAM.
3. Press MONITOR. MON flashes. Use the number keys to enter the monitor
memory's channel number, then press MONITOR. Or, tur n TUNING to select
the channel number.
MON flashes and the monitor memory's channel number and frequency
appear.
4. Press ENTER. The scanner stores the frequency in the selected channel
number.
To move the next frequency to the nex t channel, turn TUNING to select
the next channel and repeat Steps 3 and 4.
Moving Frequencies from Monitor Memories to Banks
The scanner can move frequencies stored in monitor memories into
banks you specify.
1. Press AUTO. AUTO appears.
2. Using the number keys, select the bank numbers where you want to store
the frequencies from the monitor memories.
Notes: To select bank 10, press 0.
If you select a bank that does not contain any empty channels, a
bar flashes under the bank number, and -FULL- and AUTO appear. To
store new frequencies into this bank, you must delete one or more
frequencies stored in it, then repeat Step 2. See "Deleting
Frequencies."
If you select a bank that contains an empty channel, a bar flashes
under the bank number, and AC -, the number of vacant channels in
the bank, Ch, and AUTO appear.
If you do not want to select the bank, press the bank's number
again.
If you select more than one bank and want to review your
selections, turn the TUNING knob one click for each selected bank.
As you turn the TUNING knob, a bar flashes under each selected bank
number.
3. Press and hold down ENTER, then press MONITOR . A bar flashes under the
bank number, and AC-, the number of vacant channels in the bank, Ch,
and AUTO appear.
Moving Frequencies Within Banks