Owner`s manual

PRO-2035 1000-Channel Programmable Home Scanner
(200-0460) Operation - Part 2 Faxback Doc. # 16911
SCANNING THE CHANNELS
To begin scanning the channels or t o start scanning again after monitoring
a specific channel, press SCAN. The scanner scans through all non -locked
channels in the active banks (see "Locking Out Channels").
The scanner scans either up or down through the channels in the activated
banks. To change the scanning direction, either press the UP or DOWN
ARROWS, or rotate TUNING counterclockwise to scan down, or clockwise to
scan up.
USING THE ROTARY TUNER
The scanner's rotary tuner lets you quickly select channels and
frequencies.
NOTE: If you turn TUNING too slowly, the scanner might accidentally change
the search or scan direction. If you turn TUNING too quickly, the
scanner might not display the frequency or channel you expected.
Tuning Channel Numbers
To tune a higher channel numbers, turn TUNING clockwise one notch at time.
To tune to lower channel numbers, turn TUNING counterclockwise one notch at
a time.
Tuning Frequencies
NOTE: You cannot use the rotary tuner to tune to frequencies while the
scanner is scanning the priority channel.
1. When the scanner stops on a frequency while scanning, press MANUAL.
MANUAL appears.
2. Press TUNE. MANUAL, the frequency number, and TUNE appear.
To tune to higher frequencies, turn TUNING clockwise one notch at a tim e.
To tune to lower frequencies, turn TUNING counterclockwise one notch at a
time.
USING MONITOR MEMORIES
Monitor memories are temporary storage areas where you can store up to 100
frequencies while you decide whether to save them into channels. You can
manually select monitor memories, but you cannot scan them.
You can store frequencies you find during a limit or direct search into
monitor memories by pressing MONITOR when the desired frequency appears on
the display. The channel number to the right o f MON indicates the current
monitor memory.
To listen to a monitor memory, press MANUAL, then press MONITOR. The
current monitor memory appears. To select other monitor memories, either:
Turn TUNING one click to select each monitor memory.
Use the number keys to enter the monitor memory's channel number,
then press MONITOR.