Owner`s manual

MONITOR MEMORIES
TURNING ON THE SCANNER/SETTING VOLUME AND SQUELCH
1. Turn SQUELCH fully counterclockwise.
2. Turn VOLUME clockwise until you hear a hissing sound.
3. Turn SQUELCH clockwise, then leave it set to a point just after the
hissing sound stops.
NOTE: If the scanner picks up unwanted, partial, or very weak
transmissions, turn SQUELCH clockwise to decrease the scanner 's
sensitivity to these signals. If you want to listen to a weak or
distant station, turn SQUELCH counterclockwise.
TURNING CHANNEL-STORAGE BANKS ON AND OFF
When you turn on the scanner the first time, the scanner scans all ten
channel-storage banks. As the scanner scans a bank, the bar under the
bank's number flashes.
To turn off banks while scanning, press the bank's number key until the bar
under the bank's number disappears. The scanner does not scan any of the
stored channels within banks you have turned off.
NOTES: You cannot turn off all banks. There must be at least one active
bank.
You can manually select any channel in a bank, even if the bank is
turned off.
The normal way to search is between two frequency points. Enter
PRO-
GRAM, LIMIT and the display will show the current "Lo" frequency
limit. If you want to change it, enter the frequency (146,000 for
example) and hit ENTER. Press LIMIT again to see the "Hi" frequency
limit. To change it enter the frequency (148,000 for example) and
hit ENTER. To begin the search hit the / \ to scan up or \/ to scan
down. Unit will scan between 146,000 and 148,000 in example above.
To turn on banks while scanning, p ress the bank's number key until a bar
appears under the bank's number.