Owner`s manual

Changing/Resetting the Frequency Step
The scanner scans at a preset frequency step (5, 12.5, or 50 kHz) for each
frequency range. However, if you scan some of the 225 -400 MHz and TV audio
bands, you might have to manually change the frequency step.
You can change the displayed frequency step while searching for frequencies
or automatically storing frequencies.
Follow these steps to change the displayed frequency step.
1. Display the frequency step or frequency range which uses the frequency
step.
2. Press STEP until the desired frequency step appears.
The frequency step flashes anytime it is different from the preset
frequency step.
To change the displayed frequency step back to its preset value, press
RESET.
NOTES: You cannot change the frequency step unless it appears on the
display.
Keep in mind that improperly changing the frequency step can cause
you to miss stations while scann ing. For example, if you use a 50
kHz frequency step to search for broadcasts, and the band mode is
set to NFM, you might miss frequencies between the 50 kHz steps.