Specifications

sure to use it to clearly designate the end location.
• The spacing between the line numbers and commands and between commands and
operands, facilitates reading the display. In BASIC language the spacing
has no
special meaning (except
for a PR I NT statement message) and may normally be
omitted .
• In this program, line n'umbers
have been divided into increments of 10 but they may
be freely used within a range of 1 through 9999. However, it is more convenient for
subsequent addition/insertion if they are divided into increments of 10.
Since program execution
is performed in sequence from lower numbers to higher
numbers,
use line numbers in the desired execution sequence.
•
To clear the program in one program area, use a CLEAR command. To clear all the
programs in
areas P0 through P9, use a CLEAR A command.
5-3-2 Program Execution
Program execution is performed in the RUN mode. (Press l!il[@) and "RUN" will be
displayed.)
There
are 2 methods for executing a program which has been written.
1. Program execution method
CD Execution using program area designation
For this method, execution begins as soon as the program area is designated.
~ { !} (Press ~ then press the desired program area.J
Example: To start the program in the previous example
Operation: ff!illJ ~
RUN mode
! (omitted hereafter)
~
I ?
* This "? " is displayed because an
INPUT statement is written in the
program as the first step.
®Execution using a RUN command
RUN lID ("RUN" may be input by pressing either
001]]00. or ~cID lED .)
* When performing Execution using a RUN command as in the previous example, a
") " is displayed. When the program is in an input await condition, "? " will not
be released even if mB is pressed. You must press ~~ then perform operation ®
to re-input data.
Also,
to begin execution in the middle of the program, input the desired Iine number
after the RUN command and
press the lID Key.
-32- .