Owner`s manual

OWNER’S MANUAL
Programming Device Control/Programming Device Control 7
• To decrease brightness, press # one or
more times.
3. When the desired brightness is achieved, press
HOME twice to exit programming and return to
the last-selected device menu screen.
NOTE: Otherwise, to program other features,
press HOME only once to return to the Program
Keys.
SETTING THE VIBRATION SWITCH
The Radioshack 6-in-1 Remote can be set to turn
the display on when you pick it up, before you even
press a button. Your new remote comes preset with
vibration turned on. To turn vibration sensitivity
off, perform the following steps:
1. Press and hold P until the bottom IR segment
flashes twice. The Program Keys will appear.
NOTE: If the display turns off because of
inactivity, you will need to start the
programming sequence again by repeating this
step.
2. Press OTHER once.The Other programming
screen will appear:
3. Using the Number Keys, enter 9 8 5. The
bottom IR segment flashes four times if you
are turning it OFF and twice if you are turning
it ON.
4. Press HOME twice to exit programming and
return to the last-selected device menu screen.
To turn vibration sensitivity off, repeat these steps.
PROGRAMMING DEVICE
CONTROL
The Radioshack 6-in-1 Remote is preset at the
factory to operate an RCA TV,VCR, DVD Player, or
Satellite Receiver, Pioneer CD Player, and Audio
Receiver
To control devices other than the default brands,
perform the following steps; otherwise skip this
section:
NOTE: To control a DVD Player/VCR Comb o,
perform the instructions in “Programming DVD
Player/ VCR Combo Control” on page 8.
1. Turn on a desired device (e.g.,VCR or DVD
player) and, if applicable, insert media (e.g.,
cassette or disc).
NOTE: Please read steps 2 through 9 completely
before proceeding. Before starting step 2, review
the “Manufacturer’s Codes” (starting on page
33). Brands are listed alphabetically in order of
most popular ones first. Highlight or write down
the devices and the codes you wish to program.
2. Press and hold P until the bottom IR segment
flashes twice. The Program Keys will appear.
NOTE: If the display turns off due to inactivity,
the remote control will exit programming and
return to the last-selected device menu screen.
To start programming again, repeat this step.
NOTE: To stop programming at any time, press
HOME once to return to the Program Keys
screen. Press HOME once more to exit completely.
3. Press DEV once. The Device Setup
programming screen will appear:
RS 6in1 Kam Owners Manual.fm Page 7 Monday, June 7, 2004 12:16 PM