Owner`s manual

6-IN-ONE REMOTE POWERED BY KAMELEON
6 Adjusting The Display/Adjusting The Display
DEVICE TABLE
NOTE: Please refer to the table below when
performing the instructions in “Programming Device
Control” on page 7.
After programming, the Radioshack 6-in-1 Remote
will be able to control the following types of devices:
ADJUSTING THE DISPLAY
Your new remote has several ways to adjust the
display for your comfort and best use.
ADJUSTING BRIGHTNESS
The Radioshack 6-in-1 Remote has five levels of
brightness adjustment and is set to the middle one
at the factory. To increase or decrease the
brightness, perform the following steps:
1. Press and hold P until the bottom IR segment
flashes twice. The Program Keys will appear.
NOTE: If the display turns off because of
inactivity, you will need to start the programming
sequence again by repeating this step.
2. Press (Brightness) once.The Brightness
programming screen will appear:
• To increase brightness, press ! one or
more times.
In the CBL/SAT, VCR, or DVD
modes, use the PVR/DVR
Keys as follows:
Use the replay key (on the
left-hand side)to instantly
replay the last 7 seconds of a
program you are watching (if
the feature is available).
Use the advance key (in the
center) to skip past
commercials or other
uninteresting scenes (if the
feature is available).
In the DVD or CD mode, use
the advance key to change
discs.
Use LIVE TV to switch
between live TV and video
programming (if the feature
is available).
After programming, press
Macro Key 1 – 3 once to run
a macro (see “Using Macros”
on page 15).
DEVICE KEY CONTROLS THESE DEVICES
Audio Amplifier or Audio
Receiver
Cable Box (Converter), Satellite
Receiver, or Satellite/PVR Combo
Television, TV/VCR Combo,
TV.VCR.DVD Combo, or TV/DVD
Combo
CD Player or CD Recorder
VCR or PVR (DVR)
DVD Player or Home-Theater-in-
a-Box Device
DEVICE KEY CONTROLS THESE DEVICES
RS 6in1 Kam Owners Manual.fm Page 6 Monday, June 7, 2004 12:16 PM