Owner`s manual

OWNER’S MANUAL
Using Channel Scan/Programming Favorite Channel Scan 21
USING CHANNEL SCAN
In the CBL/SAT or TV mode, use the FAV SCAN key to
start a 3-second scan of all channels. If
programmed, use the FAV SCAN key to scan only
your favorite channels to view a desired channel
(see Programming Favorite Channel Scan below).
1. Press CBL/SAT or TV once.The bottom IR
segment flashes once.
2. Press FAV SCAN once.The IR segments will
display outgoing animation as each channel is
changed.
•If Favorite Channel Scan has been set up,
scanning of favorite channels will start
and cycle through stored channels for
3minutes or until stopped by pressing
any key.
•If Favorite Channel Scan has not been set
up, scanning will start with the current
channel, then proceed to the next channel
up and cycle through all channels for 3
minutes or until stopped by pressing any
key.
3. To stop scanning channels at any time, press
any key once.
PROGRAMMING FAVORITE
CHANNEL SCAN
In the CBL/SAT or TV mode, you can store a list of up
to 10 favorite channels, in any order, that will be
immediately scanned when FAV Scan is pressed
(see Using Channel Scan above).
NOTE: Favorite channels can only be programmed
for one mode. After programming, if FAV Scan is
pressed while in another mode, the remote control
will start a normal channel scan instead (if
applicable to the selected device).
1. Press and hold P until the bottom IR segment
flashes twice. The Program Keys will appear.
2. Select a Favorite Channel Mode by pressing
CBL/SAT or TV once.The bottom IR segment
flashes once as the selected device key
animates.
3. Press OTHER once.The Other programming
screen will appear:
4. Using the Number Keys, enter 9 9 6. The
bottom IR segmentwill flash twice and display
the Favorite Channel programming screen.
NOTE: If the bottom IR segmentdisplay one
long flash, an error has occurred. Try repeating
this step.
5. Using the Number Keys, enter a favorite
channel number (e.g., 0 1 2). Then press P
once.The bottom IR segmentwill flash three
times confirming your entry.
NOTE: If the original remote control required
pressing an Enter key to change the channel,
also press the ENTER key after the channel
number (e.g., 0 1 2 ENTER).
6. If desired, repeat step 5 for each channel to be
stored, up to a total of 10 channels.
NOTE: After storing 10 channels, the remote
control will exit the Favorite Channel
programming screen and again display the
Program Keys.
7. To exit programming with less than 10 favorite
channels stored, press and hold P until the
bottom IR segment flashes twice and then
press HOME once.The display will return to the
last-selected device menu screen.
RS 6in1 Kam Owners Manual.fm Page 21 Monday, June 7, 2004 12:16 PM