Owner`s manual

8
Installation
right side) and the other is marked L (for
the left side). Insert the keys as far as
they will go (with the notches facing up)
into the appropriate slots at the middle
left and right sides of the stereo. Then
slide the sleeve off the back of the ste-
reo.
6. Insert the sleeve into the dash. Then
secure the sleeve to the dash by bend-
ing out all the tabs with a screwdriver.
7. Pull the wiring harness through the front
of the sleeve, then reconnect it to the
stereo's 14-pin wiring socket.
8. Pull the vehicle’s antenna cable through
the front of the sleeve, then reconnect
the antenna.
9. Being careful not to pinch any wires or
cables, slide the stereo into the sleeve
until it locks into place.
10. To further secure the stereo, use the
supplied hardware to attach one end of
the supplied metal strap to the mounting
bolt on the back of the stereo. If neces-
sary, bend the metal strap to fit your
vehicle's mounting area. Then use the
supplied sheet metal screw to attach the
other end of the strap to a solid metal
part of the vehicle under the dashboard.
This strap also helps ensure proper
electrical grounding of the stereo.
11. Reconnect your vehicle battery's nega-
tive (–) cable. Then replace the outer
trim ring and install the stereo's control
panel.
You might need to reset the stereo's clock af-
ter you reconnect the vehicle battery’s cable
(see “Setting the Clock” on Page 10).
REMOVING THE STEREO
FROM THE DASH
To remove the stereo from the dash, follow
these steps.
1. Make sure the ignition is turned off, then
disconnect your vehicle battery's nega-
tive (–) cable.
2. Remove the metal strap from the back
of the stereo (if attached).
3. Press
REL to remove the control panel.
4. Lift the top of the outer trim ring then pull
it out to remove it.
Outer Trim Ring
R Key
L Key
Outer Trim Ring
R Key
L Key
Sleeve
Tabs
Metal Strap
Mounting Bolt
12-2118.fm Page 8 Wednesday, May 24, 2000 12:13 PM