Install guide

cable back through the cable run between the door and the car body as the cable run is socketed.
However, I believe that somebody else on the forum has found a way of getting speaker cables
through this socket.
Wire your new cable up to the crossover and then run new lengths of cable from the crossover
through to the areas where the mid speaker and the tweeter will be mounted. Now refit the door
panel. Make sure you connect up the tweeter cable as well as the other electrical connections. Take
great care not to bend the rod that connects to the door lug and ensure that the door handle cable is
fitted correctly in it’s socket. The finished item should look like this:
That’s it! Your front speakers are fitted, now you have 6.5” component speakers in the front and the
back of the car! Replace the grilles (you will have to remove the lower mounting clip) and you
wouldn’t even know they were there. y