Owner`s manual

10
1. Make sure the ignition is turned off,
then disconnect the cable from the
vehicle's negative (–) battery termi-
nal.
2. Disconnect the 14-wire harness and
the antenna.
3. Press
RELEASE
on the upper left
corner of the control panel to
remove the control panel.
4. Take out the plastic trim ring by lift-
ing the top of the trim ring.
5. Insert the supplied keys into the slot
on both sides of the stereo. Press
the key downward and slide the
sleeve off of the stereo.
6. Insert the supplied sleeve into the
dash. Then secure the sleeve to the
dash by bending out all the tabs with
a screwdriver.
7. Reconnect the harness to the ste-
reo's 14-pin wiring socket, then
reconnect the antenna.
8. Slide the stereo into the sleeve until
it locks into place.
9. To further secure the stereo, use the
supplied hardware to attach one end
of the supplied metal straps to the
mounting bolt on the back of the ste-
reo. If necessary, bend the metal
strap to fit your vehicle's mounting
area. Then use the supplied sheet
metal screw to attach the other end
of the strap to a solid metal part of
the vehicle under the dashboard.
This strap also helps ensure proper
electrical grounding of the stereo.
RELEASE
Trim Ring
12-2156.fm Page 10 Wednesday, November 24, 1999 10:39 AM