Owner`s manual

12
on the same line is picked up or
the system detects a Calling Party
Control (CPC) signal, it stops
playing the outgoing message or
recording, and resets to answer
another call.
±
±±
±
5. When the system is off and there is
an incoming call, it will answer the
call after 10 rings and sound a long
beep, then waits seven seconds
for the remote code.
75+0)"6*'"#00170%'/
1
0.;"('#674'
Your system’s announce-only feature
lets you play a message for the caller,
then automatically hangs up without
letting the caller leave a message.
±
±±
±
To select announce-only mode,
slide
INCOMING MSG
to
ANN ONLY
(see
illustration on Page 9). When the
system receives a call, it plays the
announce-only message, then monitors
the phone line for remote codes
received within about seven seconds.
To turn off the announce-only feature,
slide
INCOMING MSG
to
ANS
.
±
"016'"
±
"
• If memory is full, three
short beeps sound
when you try to record
a memo, 2-way
conversation, or
change the outgoing
message.
<Bý
<Bý<Bý
<Bý
appears
on the display.
• Many local phone
companies use Calling
Party Control (CPC) to
signal that a caller has
hung up. Your system
can recognize a CPC
signal and release the
line.
• The announce-only
outgoing message
does not affect your
original outgoing
message. Each
outgoing message can
be recorded, played
back, or deleted
independently.
• When the system is
set for announce-only,
you cannot record
incoming messages
using remote
commands. You can
use remote commands
to perform all other
operations.
Operation