Specifications

The lap counter is a programmable counter that determines how many times the E-35 will cycle through its list of up to 5 emer-
gency number (or up to 3 “Info” phone numbers), before it stops the dialing process and hangs up. When all of the programmed
phone numbers have been dialed, the lap counter is incremented and the dialing process repeats. When the lap counter has
been met, the dialing process stops and the E-30 hangs up. * Note: This feature is disabled in the factory default setting.
Setting C - Silence Time Out
This feature selects the length of time that calls will remain connected without voice activity.
Programmable in increments of 10 seconds up to a maximum of 90 seconds (Touch Tones
1 - 9). To disable the silence time out, program 0 in this location. Use chart at the right.
* Note: The factory default is 40 seconds.
Setting D - Dial Next Number on Ring No Answer
If enabled and a ring-no-answer is detected, the E-35
phone will dial the next programmed speed dial num-
ber, and continue to cycle through the emergency
numbers until a call is completed. * Note: Factory set to redial if not answered after 7 rings.
Touch
Tone
0
1
2
3
4
5
6
7
8
9
Silence
Time Out
Disabled
10 sec
20 sec
30 sec
40 sec*
50 sec
60 sec
70 sec
80 sec
90 sec
If enabled and a busy is detected, the E-35 phone will dial the next programmed
speed dial number, and continue to cycle through the emergency numbers until a
call is completed. * Notes: This feature is enabled in the factory default setting. If
the busy signal is interrupted with a promotional message, contact your central
office to have it removed.
Setting E - Dial Next Number on Busy
Setting F - Pulse Dialing Rate (Pulses per Second)
The E-35 phone is capable of different pulse dialing speeds. * Note: The factory
default setting is 10pps (pulses per second).
Touch Tone
1
2
Setting F
10 pps*
20 pps
Touch Tone
1
2
Setting E
Disabled
Enabled*
7
Settings A /B/C-NotApplicable
F. Miscellaneous Options (memory location #17)
Dial: A +B+C+D+E+F+#+1+7
Factory Default Setting:0+0 +0+2+ 1+0
Not Applicable (enter 0)
Hang-up on Return to Dial Tone
Panasonic Mode
Lap Counter
Enter Settings Here:
A B C D E F
0 0 0 #17
If enabled and a return dial tone is detected, the E-35 will hang up.
* Note: The factory default setting is enabled.
Touch Tone
1
2
Setting D
Disabled
Enabled*
Setting D - Hang Up on Return to Dial Tone
The E-35 can be programmed to recognize the double ring cadence that is typical of
Panasonic phone systems. If the E-35 is connected to a Panasonic extension, (or any other
system that provides a double ring cadence) enable “Panasonic Mode” will allow for proper
call progress detection.
* Note: This feature is disabled in the factory default setting.
Touch Tone
1
2
Setting E
Disabled*
Enabled
Setting E - Panasonic Mode
With the lap counter disabled (factory setting), if the E-35 is programmed to dial
the next number on ring-no-answer and/or busy signal (see page 6 and 7), the
E-35 will continuously call its programmed phone numbers forever until the call
is answered.
Touch Tone
0
1-9
Setting F
Disabled*
Lap count = 1-9 times
Setting F - Lap Counter
Touch Tone
1 or 0
2, 3, 4...9
Setting D
Disabled
Dials second number after
2, 3, 4...9 rings respectively*