Specifications

2
Using Vehicle Battery Power
You can use an optional DC adapter (Cat. No. 270-1560)
to power the CD Cleaner from your vehicle’s cigarette-
lighter socket.
Caution:
You must use a DC adapter that supplies 3
volts and delivers at least 300 mA. Its center tip must be
set to negative, and its plug must correctly fit the CD
Cleaner’s
3V 300mA
jack. Using an adapter that does not
meet these specifications could damage the CD Cleaner
or the adapter.
Set the adapter’s voltage switch to 3V. Plug the adapter’s
5.5 mm outer diameter/2.1 mm inner diameter barrel plug
into the CD Cleaner’s
3V 300mA
jack. Unplug your vehi-
cle’s cigarette lighter and plug the large end of the DC
adapter cord into the cigarette-lighter socket.
Note:
If the CD Cleaner does not operate properly when
you use DC power, be sure the cigarette-lighter socket is
clean and that the adapter’s plug is pushed all the way
into the socket.
Cautions:
• Do not leave the adapter plugged into the cigarette-
lighter socket or connected to the CD Cleaner when
you are not using the CD Cleaner.
• Always unplug the adapter from the cigarette-lighter
socket before unplugging it from the CD Cleaner.
CLEANING A CD
1. Press
OPEN
. The CD Cleaner’s cover pops up. Flip
up the cover, then remove and discard the round
paper card on the CD tray.
2. Handle the CD by its edges and place it on the tray
with the label side down.
Note:
The CD tray is recessed on two sides to make
it easier to place or remove the CD.
3. Spray a small amount of cleaning fluid onto the CD
from about 3 inches away.
4. Close the cover, then press
POWER
. The CD
Cleaner’s cleaning pad rotates and cleans the CD for
about 20 seconds, then stops automatically. (You do
not need to press
POWER
again to stop the CD
Cleaner.)
5. Press
OPEN
, then flip up the cover and remove the
CD by its edges. Close the cover, to keep the clean-
ing compartment dust-free.