Owner`s manual

ManualsBrandsRadio Shack ManualsBusiness equipmentAstro

Preparation

Note:

For TV/VCR combinations, press

VCR

and

use the VCR code listed for your model under “TV-

VCR Combo Codes” on Page 33. If your TV/VCR

combination also lists a TV code, you must program

the TV separately by repeating Steps 3–5 to add

volume control. In Step 3, press

, then in step 4

enter the TV code.

4. Hold down

until the remote’s red light blinks twice,

then release

. Enter the first 4-digit manufacturer’s

code for the desired device. When the red light

blinks twice, the remote control has accepted the

code.

For example, to set up the remote control of a Pana-

sonic TV (manufacturer’s code 0051), press

hold down

until the red light blinks twice, then

release

and press

0 0 5 1

Note:

If you entered the code incorrectly, the red

light emits one long blink.

5. Point the remote control at the desired device and

press

POWER

. The device should turn off.

If the remote control does not operate your device,

try the other codes listed in “Manufacturers’ Codes”

on Page 20 for your brand of device. Otherwise, use

the search method to find a working code — see

“Manual Code Search” on Page 17.

6. Repeat Steps 3–5 to program other devices.

Note:

If the remote control does not operate all

device functions, try using another code in the list

that may be more compatible.

PROGRAMMING FAVORITE CHANNEL

SCAN

Once they have been programmed into a favorite chan-

nel table, you can scan up to ten favorite channels for a

desired device.

Note:

Once you have programmed

SCAN/FAV

for Favor-

ite Channel Scan, you cannot use it for Channel Scan

unless you reset it (see “Resetting Scan” on Page 10).