Owner`s manual

Operation

MANUAL CODE SEARCH

If your home entertainment device does not respond to

remote control commands after trying all of the codes

listed for your brand, or if your brand is not listed, try

searching for your code.

For example, if after trying all of the codes for your TV,

you still cannot get the remote control to operate your

TV, use the manual code search.

Follow these steps to search codes manually.

1. Turn on the desired device.

2. On the remote control, press the appropriate device

key once.

3. Hold down

until the red light blinks twice.

4. Press

9 9 1

. The red light blinks twice.

5. Aim the remote control at the desired device and

slowly alternate between pressing

POWER

and the

appropriate device key. Stop when the device turns

off — a code that works has been found.

Note:

In the search mode, the remote will send IR

codes from its extensive library to the selected

device, starting with the most popular codes.

Because of the library’s size, this procedure may

take some time. When the red light blinks three

times, the search of every code is complete.

6. Press

once to lock in the code.

Note:

If the device turns off during the search, but does

not operate after you lock in the code, begin the search

again, pausing longer between key presses.

Checking Your Code

If you have set up the remote control using the manual

code search procedure, you can use the following in-

structions to find out what code is operating your equip-

ment: