Owner`s manual

14
Operation
ˆ Operation
Note:
The command keys on the remote control work
the same as the keys on your original remote controls.
However, the labeling may be different.
USING THE REMOTE
1. Point the remote at the desired device and press the
device key (
TV
,
VCR
,
CBL/SAT
, or
DVD
). Then press
POWER
to turn on the device.
2. Press the desired command keys.
3. Repeat Steps 1 and 2 for all other devices you want
to operate.
4.
To turn off the last device you selected
, press
POWER
.
To turn off another device
, press the device key,
then press
POWER
. Repeat this step to turn off all
devices.
Note:
You can program
POWER
as a master power key
to turn all devices on and off in a sequence. See “Pro-
gramming the Power Key” on Page 12.
USING THE LIGHT
Your remote has a backlight so you can see the keys in
the dark. To turn on the light, press at the top right
of the remote.
When you press a key, the remote lights for a few sec-
onds. To turn off the light, press again.
USING CHANNEL SCAN
Important:
If you have set up
SCAN/FAV
for Favorite
Channel Scan, you cannot use Channel Scan until you
reset
SCAN/FAV
(see “Resetting Scan” on Page 10).
If you want to view a sample of every channel on your
cable or SAT/DSS service, press
CBL/SAT
, then press