Owner`s manual

10
Preparation
1. Select either
TV
or
CBL/SAT
for the favorite channel
scan.
2. Hold down
P
until the red light blinks twice.
3. Press
9 9 6
to start the program.
4. Enter a desired two-, three-, or four-digit channel
number (for example, 050 or 0500), depending on
your device.
If you entered a two- or three-digit channel number
,
you must next do one of the following:
• If your original remote requires you to press Enter
or Select to send a command, then do so after
entering the digits of your favorite channel.
• If your original remote does not require you to
press Enter or Select to send a command, then
after entering your two- or three-digit channel
number, press
P
.
If you entered a four-digit channel number
, do not
press
P
.
5. Repeat Step 4 up to nine more times to store
another favorite channel for the same device, or exit
the program by pressing
P
until the red light blinks
twice.
Note:
Upon entering the tenth channel, the remote
exits favorite channel programming.
Programming Favorite Channel Scan for a second de-
vice deletes the programming for the first.
Resetting Scan
Once you have programmed
SCAN/FAV
for Favorite
Channel Scan, you cannot use it for Channel Scan un-
less you reset it.
To reset
SCAN/FAV
, follow these steps.
1. Select either
TV
or
CBL/SAT
.
2. Hold down
P
until the red light blinks twice.