Owner`s manual

12
MOUNTING THE
STEREO
Be sure you test all connections first,
then follow these steps to mount the
stereo.
1. Disconnect the cable from the
vehicle battery’s negative (
–
)
terminal.
2. Disconnect the wire harness and
the antenna.
3. Carefully remove the trim plate
from the front panel to expose
the removal slots at the left and
right sides of the stereo.
4. Insert both of the supplied keys
into the slots at the left and right
sides of the stereo, and slide the
sleeve off of the stereo.
5. Insert the sleeve into the dash.
Then secure the sleeve to the
dash by bending out all appro-
priate tabs with a screwdriver.
Bend out all the side tabs.
6. Reconnect the wire harness and
the antenna.
7. Re-attach the trim plate.
8. Slide the stereo into the sleeve
until it locks into place.
9. To further secure the stereo,
remove the rubber cap from the
bolt on the back of the stereo,
then use the supplied hardware
to attach one end of the supplied
metal strap to the bolt.
10. If necessary, bend the metal
strap to fit your vehicle’s mount-
ing area. Then attach the other
end of the strap to a solid metal
part of the vehicle. This strap
also helps ensure proper electri-
cal grounding of the stereo.
1
6
5
3
4
2
Removal Slots
Removal Slots
1
6
5
3
4
2
12-2108.fm Page 12 Wednesday, July 14, 1999 10:07 AM