Owner`s manual

9
Connecting Two Pairs of Speakers
If you are using both front and rear speakers, follow these steps to connect the
harness to the speakers.
1. Use a small screwdriver to move
2 ch/4 ch
on the bottom of the stereo to
4
ch
(four channel).
2. Connect the gray wire to the right front speaker’s positive terminal. This ter-
minal is usually marked with a plus (+) sign or red mark.
3. Connect the gray/black wire to the right front speaker’s negative terminal.
This terminal might be marked with a minus (
–
) sign or it might not be
marked at all.
4. Connect the white wire to the left front speaker’s positive terminal.
5. Connect the white/black wire to the left front speaker’s negative terminal.
Left Right
Front
Rear
Front
Rear
White
White/Black
Green/Black
Violet/Black
Gray/Black
Gray
Violet
Green
12-2113.fm Page 9 Wednesday, July 14, 1999 12:18 PM