Owner`s manual

8
Installation
To a TV with a DBS Receiver or
Other A/V Device
If your DBS receiver or other A/V component
is connected to the TV using A/V cables, you
can connect the receiver to the free LINE IN
jacks on the component. If there are no LINE
IN jacks, use a TV antenna splitter (available
at your local RadioShack store).
SETTING THE REMOTE
CONTROL’S HOUSE CODE
The house code is a master code for a Plug
‘n Power system. You must set the camera
and the remote control to the same house
code. There are 16 codes to choose from
(A–P).
Setting or Changing the Remote
Control’s House Code
1. Hold down
1 ON
on the remote control.
After about three seconds, the light
blinks the current setting. For example,
the light blinks once for house code A,
twice for house code B, and so on.
2. Release
1 ON
.
3. Press
1 ON
the appropriate number of
times for the house code you want to
set, such as once for A or twice for B.
The light blinks each time you press
1
ON
. On the last press hold down
1 ON
for
about 3 seconds. The light blinks the
new setting.
Note:
If you do not follow this programming
sequence, the light stays on for about 1 sec-
ond and the existing setting is not changed.
SETTING THE REMOTE
CONTROL’S UNIT CODE
Every camera has a unit code dial with set-
tings from 1–16. You can set the control sys-
tem to control any camera(s) set to the same
house code.
After you install the battery, the remote con-
trol is preset to house code A. The
1–4 ON/
OFF
keys are set to unit codes
1
,
2
,
3
, and
4
respectively.
Setting or Changing the Unit Code
To control a camera with a different unit
code, follow these steps to change the re-
mote control’s unit codes.
Notes:
• You only need to change the unit code
of the
1 ON/OFF
key. The other keys are
always one number higher than the pre-
vious one(s). For example, if you set
1
ON/OFF
to unit code
5
,
2 ON/OFF
controls
6
,
3 ON/OFF
controls
7
, and
4 ON/OFF
controls
8
.
• The unit code must be set in sequence
of [
1 2 3 4
], [
5 6 7 8
], [
9 10 11 12
], or [
13 14
15 16
]. Setting the codes across any of
these sequences (such as
3 4 5 6
)
causes the cameras to interfere with one
another.
1. Hold down
1 OFF
. After about three sec-
onds, the light blinks the current setting.
For example, the light blinks once for
unit code
1
, twice for unit code
2
, and so
on.
2. Release
1 OFF
.
3. Press
1 OFF
the appropriate number of
times for the unit code you want to set.
The light blinks each time you press
1
OFF
. Hold
1 OFF
on the last press for
about 3 seconds. The light blinks the
new unit code.
Note:
If you do not follow this programming
sequence, the light stays on for 1 second
and the existing setting is not changed.