Owner`s manual

9
Operation
ˆ
Operation
Set the receiver’s
ON/OFF
switch to
ON
. The
red indicator on the front of the receiver
lights. Turn on the connected devices. If nec-
essary, remove the camera’s focus panel
cap, then adjust the lens to set the focus.
If you cannot get any signal, make sure:
• the channel switches on both the cam-
era and the receiver are set to the same
channel
• the TV and the
TV CHANNEL 3/4
switch
on the bottom of the receiver are set to
the same channel (if you are using coax-
ial TV connections for the receiver)
• to turn on the camera using the remote
control
If the signal is poor, or there is interference:
• Adjust the camera and receiver’s
antenna so they face one another.
• Change channels on both the camera
and the receiver.
To turn off the camera without using the re-
mote control, unplug the Plug ’n Power
adapter from the AC outlet.
USING THE REMOTE
CONTROL
You can set the system up to control four
cameras, using the remote control. You can
find additional cameras at your local
RadioShack store.
See “Setting the Remote Control’s House
Code” on Page 8 and “Setting the Remote
Control’s Unit Code” on Page 8 to set up the
remote.
Press the
ON/OFF
keys that have been set to
the corresponding unit codes to turn the
camera(s) on or off.
Notes:
• The cameras are preset to on when they
are connected to power.
• When you turn on one camera, the other
three are off.
• You can use the remote control and
transceiver to control lights and appli-
ances connected to separate Plug ’n
Power modules, available at your local
RadioShack store.
• To dim and brighten lights connected to
Plug ’n Power dimmer and light switch
modules, you must purchase additional
Plug ’n Power remote and transceiver
sets. Any additional sets and this sys-
tem’s transceiver must be set to different
house codes in order to work properly.
SCANNING
All Four Cameras
To scan through all four cameras, press
FORWARD
or
BACK
on the remote control.
The four cameras turn on in sequence. Each
camera stays on the TV or monitor for about
5 seconds.
Two or Three Cameras
1. Reset the Plug ’n Power adapter by
unplugging it from, and re-plugging it
into, the AC outlet.
2. Press the
ON
key that corresponds to
the unit code for the first camera you
want to control.