Operating instructions

Connecting your equipment
02
18
En
02
Connecting antennas
Connect the AM loop antenna and the FM wire antenna as
shown below. To improve reception and sound quality,
connect external antennas (see Using external antennas
below).
1 Push open the tabs, then insert one wire fully into each
terminal, then release the tabs to secure the AM antenna
wires.
2 Fix the AM loop antenna to the attached stand.
To fix the stand to the antenna, bend in the direction
indicated by the arrow (fig. a) then clip the loop onto the
stand (fig. b).
3 Place the AM antenna on a flat surface and in a direction
giving the best reception.
4 Connect the FM wire antenna into the FM antenna
socket.
For best results, extend the FM antenna fully and fix to a wall
or door frame. Don’t drape loosely or leave coiled up.
Using external antennas
To improve FM reception
Use an F connector (not supplied) to connect an external FM
antenna.
To improve AM reception
Connect a 5 m to 6 m (16 ft. to 20 ft.) length of vinyl-coated
wire to the AM antenna terminal without disconnecting the
supplied AM loop antenna.
For the best possible reception, suspend horizontally
outdoors.
Connecting to the front panel video terminal
Front video connections are accessed via the front panel
using the INPUT SELECTOR or VIDEO2 button on the remote
control. There are standard audio/video jacks. Hook them up
the same way you made the rear panel connections.
• Push down on the PUSH OPEN tab to access the front
video connections.
ANTENNA
FM
UNBAL
75
AM LOOP
2
1
3
4
fig. a
fig. b
ANTENNA
FM
UNBAL
75
F connector
ANTENNA
AM LOOP
Outdoor
antenna
5 m to 6 m
(16 ft. to 20 ft.)
Indoor antenna
(vinyl-coated wire)
AUDI O
VIDEO
OUTPUT
MCACC
SETUP MIC
L AUD O R VIDEO
VIDEO 2 NPUT
iPod
iPhone
iPad
USB
5V 2 1
A
PHONES
This receiver
Video camera, etc.