Owner`s manual

Need help? Call 1-800-763-9232
38
1. Plug the IR signal extension cord into
the jack (shown here) on the back of the
Command Center.
2. Route the IR extender
signal extension cord
to the device.
3. Use the supplied
double-sided tape to
attach the IR signal
extension cord to the
device, with its LED
on or next to the
device’s IR sensor.
4. Be sure the remote is not pointing
toward your equipment, then test the
Command Center by pressing
POWER
.
The Command Center converts the 7-in-
one’s RF signal into an IR signal, and
transmits that signal to the device
through the cord.
FCC Caution:
This device complies with
Part 15 of the
FCC Rules
. Operation is sub-
ject to the following two conditions:
1. This device may not cause harmful in-
terference, and
2. This device must accept any interfer-
ence received.
15-1995.fm Page 38 Thursday, March 2, 2000 7:40 AM