Owner`s manual

11
Preparation
4. Install three AA batteries as
indicated by the polarity symbols
(+ and –) marked inside the
compartment.
5. Replace the cover and secure it
with the screws.
Notes:
• At temperatures below –4
°
F
(–20
°
C), we suggest using
RadioShack lithium batteries in
the remote sensor.
• If flashes in the remote
sensor information area of the
Weatheradio’s display, and the
battery indicator on the remote
sensor flashes twice in 30
seconds, replace the batteries.
• The remote sensor sends data to
the Weatheradio once when the
batteries are installed, and every
30 seconds after that.
SETTING THE CLOCK
1. Press
MENU
. When
7(03(5$785(
7(03(5$785(7(03(5$785(
7(03(5$785(
appears, repeatedly press
∧
∧∧
∧
or
∨
∨∨
∨
#
until
6(7#&/2&.
6(7#&/2&.6(7#&/2&.
6(7#&/2&.
appears.
2. Press
>
>>
>
to set the time. The hour
digits flash.
3. Repeatedly press (or hold down)
∧
∧∧
∧
or
∨
∨∨
∨
to set the hour.
4. Press
>
>>
>
. The minute digits flash.
Repeatedly press (or hold down)
∧
∧∧
∧
or
∨
∨∨
∨
to set the minutes.
5. Press
>
>>
>
.
$0
$0$0
$0
or
30
3030
30
appears. Press
∧
∧∧
∧
or
∨
∨∨
∨
to select
7C
7C7C
7C
or
FC
FCFC
FC
.
6. Press
>
>>
>
. A beep sounds.
7. Press
MENU
to return to the clock
display.
When there is no alert displayed, the
time continuously appears. When an
alert appears in the display, press
CLOCK
to view the time for 10
seconds.
CHOOSING
LOCATIONS
Caution:
Do not place the
Weatheradio or remote sensor where
they will be in direct sunlight, near
electrical appliances, or heating/air
conditioning vents.
You can set your Weatheradio on any
flat surface (such as a shelf or
counter top). For the best reception,
choose a location where:
• it can receive alert signals
• you can hear its alert tone (see
“Setting the Alert Volume” on
Page 18)
• you can fully extend the built-in
antenna
Note:
Position the Weatheradio away
from obstructions such as metal
cabinets or bookshelves. Do not
place the Weatheradio near any
metal surface such as a refrigerator, a