Specifications

19537P-26 (11-12)
5
of 15
1. Surface Mounting the M-RIM
Parts/Tools Required
 Multiple-Radio Interface Module (41021G-01)
 Pencil/Pen
 Drill
 3/16” Drill Bit
 Drilling Template (Figure 3)
 Philips-head screwdriver
 Flat-head screwdriver
 11/32-inch nut driver or wrench
Procedure
Location Considerations
Select a location on a flat surface that is out-of-the-way, and provides adequate room to attach all
cables. Be sure to allow for internal access, as adjustments may be necessary. The M-RIM is
weather resistant, however the mounting location should be chosen to minimize direct exposure
to the elements.
Mounting
 Using a Philips screwdriver, remove the 4 screws on the cover of the M-RIM and lift off the
cover. Observe the 4 mounting holes in each corner, as shown in Figure 2.
 Position the M-RIM Drilling Template and mark each hole with a pencil.
 Confirm the location and carefully drill each hole using the drill and 3/16” bit.
 Position the M-RIM and insert a 3/16” machine screw into each mounting hole.
 On the backside of the mounting wall, use the provided flat washer and lock nut to secure
the M-RIM (Figure 2).