Specifications

19537P-26 (11-12)
13
of 15
 Connect the cable to the jack on the M-RIM labeled “Power”, see Figures 1&4. To connect the
cable to the M-RIM, align keyways and push. Then push and turn collar clockwise until it locks
into place. Pull back gently on the cable to ensure connector is properly locked.
Before continuing, ensure that power is shut off to the point where you are
going to connect the power cable!
 Using the wire cutters and wire strippers, prepare the end of the cable as necessary for your
installation (Figure 7).
 If using the David Clark 2-Amp Fuse Kit, please see Appendix A for assembly instructions.
 Connect the cable to the power source
o Connect the RED to the positive (+) terminal.
o Connect the BLACK and SHIELD to the negative (-) terminal.
 Do not turn on power at this time, wait until Section 6. Testing & Troubleshooting.
To 2 amp
circuit
breaker/fuse
RED
BLACK/SHIELD
Figure 7: C98-20PW Power Cable