Owner`s manual

4. Hold down PUSH TO TALK on the microphone, then turn

VOLUME clockwise until it clicks. The transceiver sets the

CTCSS code. Release PUSH TO TALK.

If the transceiver beeps once and RX lights green for about

2 seconds, that means the CTCSS setting was successful.

If the transceiver beeps 3 times and TX lights red for about 2

seconds, the CTCSS setting did not work. Start over at Step

5. Use a pointed object such as a straightened paper clip to set

6-DIP switch to “000000”.

6. To activate the CTCSS code you set, set the CTCSS switch at

the front panel to ON. To deactivate the code, set the switch

to OFF.

Note: If the CTCSS code is set to “000000”, that means

CTCSS function is deactivate even if the CTCSS switch on

front panel is set to ON.

19-1210.fm Page 26 Tuesday, August 3, 1999 11:32 AM