Owner`s manual

10
SELECTING A CHANNEL
Note:
You can only select, or scan,
channels when you set two or more
channels.
To manually select a channel
, press
¿
/ or
À
/
SKIP
. The selected channel
number appears.
To scan through the channels
, hold
down
¿
/ or
À
/
SKIP
for about 2 sec-
onds.
6&$1
6&$16&$1
6&$1
appears. The transceiver
automatically scans through the chan-
nels and pauses on each active chan-
nel for about 5 seconds. Press
¿
/ or
À
/
SKIP
to change the scan direction.
Press any key other than
¿
/ or
À
/
SKIP
to stop scanning.
To skip a channel to be scanned
,
press
¿
/ or
À
/
SKIP
to select the de-
sired channel. Hold down
MON/FUNC
and press
À
/
SKIP
. (skip icon) ap-
pears.
To resume scanning the skipped chan-
nel
, select the skipped channel, hold
down
MON/FUNC
, and press
À
/
SKIP
.
disappears.
USING QUIET CODE
SCAN
1. Press
QUIET/Q-SCAN
to turn on
quiet code.
48,(7
48,(748,(7
48,(7
and the quiet
code appear.
2. Hold down
MON/FUNC
, then press
QUIET/Q-SCAN
.
6&$1
6&$16&$1
6&$1
appears.
When matching with an appropri-
ate quiet code, the transceiver
stops scanning and
48,(7
48,(748,(7
48,(7
flashes.
The transceiver goes on scanning
after the signal disappears.
3. Press any key other than
QUIET/Q-
SCAN
to stop scanning. The trans-
ceiver stays on the quiet code just
scanned.
Note:
If you press
QUIET/Q-SCAN
to
stop scanning, the transceiver stays on
the pre-set quiet code.
SETTING KEY TONE
Hold down
MON/FUNC
and press
¿
/
to turn the key tone beep on or off.
(tone icon) appears when the key tone
is on.
Note:
The key tone does not beep
when you press
LOCK/PTT or MON/
FUNC
, even if the key tone is on
.
USING APO/HI/LO
Press
APO/HI/LO
to set the transmitting
power to high for long distance trans-
mission or low for short distance trans-
mission.
+,
+,+,
+,
or
/2
/2/2
/2
appears.
Hold down
MON/FUNC
and press
APO/
HI/LO
to turn Auto Power Off function
on or off.
$3#
$3#$3#
$3#
21
2121
21
or
$3#
$3#$3#
$3#
2)
2)2)
2)
appears.
When Auto Power Off is on, the trans-
ceiver automatically turns off when it is
idle for 2 hours.
Press any key to turn the transceiver
back on.