Owner`s manual

8
REMOTE N.O.
(
Normall
y
O
p
en
)
Terminals
—these
terminals connect to your alarm system’s remote
arm/disarm terminals. They provide the switch clo-
sure needed to arm and disarm the alarm.
Note:
Some systems require connection to nor-
mally closed remote arm/disarm terminals. If your
system has a normally closed switch, you must set
LATCH
to
IN
and enter your code twice to arm and
disarm the system.
TAMPER/PANIC (N.O.)
Terminals
—these terminals
connect to the alarm’s normally open tamper/panic
loop. These terminals provide the signal to trigger
your alarm if someone tampers with the keypad or
you press
#
and Q on the keypad at the same time.
Note:
If your system only has a normally closed
panic loop, do not use these terminals.
49-537.fm Page 8 Thursday, August 19, 1999 9:16 AM