Owner`s manual

PANIC CIRCUIT

If you connected the keypad’s

PANIC

terminals to a

24-hour panic/tamper loop on your alarm system,

pressing

and Q at the same time trips the alarm,

whether or not the system is armed.

On some alarm systems, you can silence the panic

alarm by entering your code at the keypad. If this

does not work, reset it at the main alarm system.

TESTING THE SYSTEM

Important

: To prevent false alarms when testing

your system, be sure to disconnect security dialers

or any other devices that send a message to a

remote location.

Your alarm system sounds dur-

ing these tests. Be sure to notify your neigh-

bors and any proper authorities of the test.

Check the system once a week to be sure it is

operating properly. Refer to the main control unit’s

operation instructions for proper test procedures.

49-537.fm Page 21 Thursday, August 19, 1999 9:16 AM