Owner`s manual

19
ARMING/DISARMING THE
ALARM
To arm the system,
enter your code. If you con-
nected the keypad to your system’s remote arm
indicator terminals, the ARM indicator should light.
Note:
If the ARM indicator lights when the system
is disarmed, you have probably connected the key-
pad to the wrong remote arm terminals on the
alarm system. Check all connections and try again.
To test the system,
arm the system, then set off
the alarm to confirm its operation.
To disarm the system,
enter your code. If you
enter an incorrect code, you must wait 10 seconds
to try again.
Notes:
• The keypad does not accept any key input for
2
1
/
2
seconds after you enter your code.
49-537.fm Page 19 Thursday, August 19, 1999 9:16 AM