Owner`s manual

15
• When set to
OUT
, the keypad shorts the
remote terminals for 2
1
/
2
seconds when you
enter the code. Use this setting if the original
arm/disarm switch is a spring-loaded type,
normally-open switch that has a momentary
contact.
If you are not sure what setting to use with your
system, check your system’s owner’s manual
or contact the manufacturer.
Notes:
•Set
LATCH IN/OUT
before you connect
power to the switch. If you set it after power
is applied, the keypad might not recognize
the changed setting.
• If your system uses a normally-open switch
and you have to enter your security code
twice to arm/disarm the system, set
LATCH
to
OUT
.
7. Remove the screw from the bottom of the key-
pad. Then remove the keypad’s front cover.
49-537.fm Page 15 Thursday, August 19, 1999 9:16 AM