Owner`s manual

13
INSTALLATION
Installation Hints:
• Before installing the keypad, temporarily con-
nect the alarm and the keypad terminals to con-
firm proper operation. If you have problems, see
“Problem Solving.”
• Install the switch indoors away from dust, dirt,
and temperature or humidity extremes.
Refer to the illustration on Page 16 and follow
these steps to install the switch.
1. Select a location on the wall next to a wall stud.
2. Use a single-gang electrical box as a template
and make a hole the size of the electrical box.
3. Route connection wires from the alarm system
to the hole (through attic, walls, and so on) and
through a knock-out plug in the electrical box.
Leave extra wire for connection to the keypad.
4. Insert the box into the hole and nail it to the
wall stud; the box should be recessed slightly
below the surface of the wall.
49-537.fm Page 13 Thursday, August 19, 1999 9:16 AM